I have upgraded my 2-star rating for Wireless Throughput to 4-stars and upgraded my 2-star rating for Wireless Stability to 3-stars. Next to the ether1 interface, click on the D icon to disable it. All in all, with RouterOS, excellent wired performance and good WiFi performance for a router, the hAP ac2 is shaping up to be a useful little device to have around. We need to disable the DHCP client mechanism so that the router does not try to obtain an IP via DHCP on the WAN interface, and we also need to ensure that the DNS servers are set within the DHCP server. There's a couple more steps that we need to take to finish the setup. After hitting Apply > OK, the reachable via a certain interface should auto populate.Īfter adding the default route, if you go back to the routes page you'll see something similar to the screenshot below. The subnet mask/IP block is not necessary. In this example, our gateway address is 172.16.1.1. Only enter in the gateway IP address here. The gateway IP address will be given to your by your Internet service provider. Address enter in the following: 0.0.0.0/0 To create a default route for traffic, navigate to IP > Routesįor the Dst. For the interface select ether1. This is the Internet/WAN-side interface for the MikroTik hAP ac2.Ĭlick Apply and then click OK. The Network option should be automatically populated for you.Your Internet service provider will provide you with this information. This equivalent to a subnet mask of 255.255.240.0. In the screenshot below our static IP address is 172.16.1.200 and our network block is /20. Note that this has to be in CIDR notation. In the address box enter your static IP address along with the subnet mask. To add your static IP address to an interface, navigate to IP > Addresses on the left-hand side. This way, any networks that the router doesn't know how to get to, it will pass that traffic onto the next router (the ISP).Īdding static IP address to WAN interface The static IP needs to be set on the WAN/Internet interface of the MikroTikĪ default route needs to be added to the device. In the event that you have been given a static IP from your Internet provider, you can refer to this guide for assistance on configuring your static IP address on your MikroTik hAP ac2 device running RouterOS.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |